OrinocoGlass Garneleneier-Retter Shrimp Egg Incubator

SKU: FC-ET
Category: Freshwater

Device for rescuing shrimp eggs in case of death of the mother animal

12,40 €

incl. 19% VAT , plus (Paket)

8 pcs In stock
Delivery time: 1 - 2 Workdays (Other countries)

pcs

The Orinoco Glass Shrimp Egg Tumbler facilitates the incubation (hatching) of shrimp eggs if the mother animal has died shortly before the release of the young. The Shrimp Egg Tumbler has a constant current due to the suction effect, which is very similar to the fanning of pregnant shrimp.

Especially with high breeding animals the use of the Shrimp Egg Tumbler is worthwhile, one has good chances to save at least the precious young animals, if the pregnant mother has died.

Scope of delivery:

Shrimp Egg Tumbler made of glass
Metal sieves with seal (2x)
Air tap (valve) for regulating the air supply
Air hose made of silicone (1,5m)
Suction cups for fastening (2x)

A diaphragm pump/air pump is additionally required (= not included in the scope of delivery).
You can also find these in our offer, if none are available.

measurements:

Total height : 8,5 cm
height of the slip chamber: 2,5 cm
Pipe diameter: 2 cm

Installation:

Fasten both suction cups
Turn the glassware so that the opening of the air tube glass tube points downwards.
Install the inner stainless steel grille with rubber seal in the pipe (moisten the seal beforehand) so that the grille is slightly above the height of the central glass nipple. The use of tweezers is helpful here.
Place the air hose on the thinner glass tube.
Then lay the eggs on the inner grid.
Close the Egg Thumbler with the outer stainless steel grid (moisten the seal beforehand).
Attach the incubator in the aquarium to a side window using the suction cups.
Close the supplied air tap and attach it to the air hose.
Connect air hose with air tap to a diaphragm pump
Open the air tap very slowly until the eggs are moved very slightly in the suction.